SpeedFactory Racing 4 Bar MAP Sensor for K Series (1-43+PSI) Engine To order your Vitara pistons

To order your Vitara pistons with your SpeedFactory long rods

You must run at least a -12AN feed line and a large bodied pre-filter (we run a Weldon with 100 micron stainless steel element) to maximize filtering surface area without causing a restriction

or return systems

and is compatible with almost every electronic boost controller and tuning software

These studs also fit many other applications using M10 x 1

SpeedFactory Racing 4 Bar MAP Sensor for K Series (1-43+PSI) Engine To order your Vitara pistonsSpeedFactory 4 Bar MAP (Manifold Absolute Pressure) sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each micro chip. Pressure changes are calculated on a true linear 0 5 volt scale via a specially designed silicon pressure sensor that also compensates for temperature changes. The unique ability to compensate for temperature changes allows our MAP sensor to remain a minimum of 99% accurate from 32